Tibbo temhum sensor configuration

We have just installed a new Temp/Humidity sensor. I was able to configure it through the DS manager. I then added the device to Serverscheck but the device shows 0 checks and is not producing a graph.

What is the output when run from command prompt in the agents subdirectory following:



sensor_check -L log.txt -C TCP X.X.X.X:3001



where X.X.X.X is the IP address of the tibbo device







Last post will be moved as new topic as this topic relates to the new PoE sensors.

What is the output when run from command prompt in the agents subdirectory following:



sensor_check -L log.txt -C TCP X.X.X.X:3001



Where do I run this from?



This is not a PoE device.

The agents subdirectory of the main ServersCheck directory. In there you will find an executable called 'sensor_check.exe'

Output is:



Device Model = Temperature/Humidity Sensor

Device Status = Normal

Firmware Version = 5.00

Number of variables = 5

Variable 1: HUMIDITY (1 % RESOLUTION) 52 % RH

Variable 2: HUMIDITY (0.1 % RESOLUTION) 52.5 % RH

Variable 3: TEMPERATURE (0.5 C RESOLUTION) 18.5 C

Variable 4: TEMPERATURE (0.1 C RESOLUTION) 18.4 C

Variable 5: HASH ID 51514

Ok so sensor works fine.



How have you set it up in the ServersCheck Monitoring software compared to setup described in the user manual?

I added the sensor by clicking on the "monitor another device" button. I am running version 8.2.4 and the setup would seem to be a bit different than the wiki.

Did you follow the Wiki or the quick user guide (PDF - pages 7-9)?



You need to click on ADD NEW MONITOR or ADD MONITOR



and then select TEMPERATURE as monitor type. In the drop down box, make sure to select the TEMPERATURE & HUMIDITY sensor and Network as communication protocol.

Yes, I added the device then added monitor. It is setup as a network device with the correct IP address. It test fine when i ran the Test Settings button.

What license do you have and how many monitors do you have defined?



When running what is the error message?

I restarted the monitoring service on the appliance and now it is recording checking the sensor.